Packing Bag + 12g Instant Glue with No drop Dispensing Needle + Cover
The name of each part of the No drop Dispensing Needle.
Polymerization curved surface on the Dispensing Needle (Nine Concave Points)
Remove the outer cap, and remove the needle without removing the small cap of the dispensing needle.
Put the dispensing needle directly on the bottleneck.
After putting the dispensing needle on the bottleneck use a pressure on the needle to get through the sealed bottleneck. The red arrow shows the position, where should be a small gap.
With pressure and little rotation on the needle the two joints will seal the bottle.
The dispensing needle directly toward to the bottle end, mount on the bottle end, and apply a pressure to stab through the sealed bottle end, again press and a little rotation, let's complete sealed.
Remove the cap of the dispensing needle, after removing the internal pressure of the bottle, you can start to use the instant glue.
Light pressure bottle, only one drop will leave the needle.
Instant glue is squeezed, single drop dripping.
Example of using the instant glue.
Example of using instant glue on ABS material. The glue can be used to coat the surface.
When using or placed for a few days, the dispelling needle will be clogged.
Please note the nine pits on the front of the needle.
Prepare a traditional lighter, it can adjust the fire large and small.
The flames of the lighter are adjusted to a minimum.
Use a lighter to heat up the concave points with a small flame.
To many times back and forth of the heating method, the needle tube instantaneous solidification of the film will be melting, vaporization.
IENA 97' , Nuremberg Silver Award
iNST 96' , Golden Brain Award
Green Design 97'
This guide was inspired by www.refillhouse.com/index.php…