First, you gather all of your supplies.
Then, you cut the ribbon. You should be able to wrap it around your wrist 3-4 times.
Tie a loop knot in the middle of your ribbon. Then, tape it to a table. (This makes the next steps a lot easier)
Thread a tab through the two ribbon strands.
Thread the ribbon over the top of the next tab.
Now, thread the ribbon through both tabs.
Pull the ribbon back through the second tab.
Repeat that until your bracelet is your desired length.
Sew a button onto the end of your bracelet.
Cut off any extra ribbon from the bottom.
Enjoy your pop tab bracelet!