How to Make Origami Sonobe Cube

Just a fun & classic origami cube. Fun to put together. Use 6 squares of paer any size for one cube. Vary the sizes large to small for a quick mobile (string them in one vertical line).

4.5k Views 523 Likes
How to Make Origami Sonobe Cube
4 Steps
Supplies
Embed
1
Fold in 1/2. Unfold. Fold top edge & bottom edge to center crease. Unfold. Fold top left corner & bottom right corner to 1st crease. Fold top & bottom edge back to center.

Fold in 1/2. Unfold. Fold top edge & bottom edge to center crease. Unfold. Fold top left corner & bottom right corner to 1st crease. Fold top & bottom edge back to center.

2
Fold bottom left corner up to top edge. Fold top right corner to bottom edge. On left side, open slightly to tuck under flap where my finger is. Repeat on right side, tucking where my thumb is.

Fold bottom left corner up to top edge. Fold top right corner to bottom edge. On left side, open slightly to tuck under flap where my finger is. Repeat on right side, tucking where my thumb is.

Recommended For You
3
TURN OVER. Fold bottom up as shown. Fold top down as shown. Let those 2 folds come open. These are flaps u will use to tuck into pockets (pockets are on opposite side). Make 6.

TURN OVER. Fold bottom up as shown. Fold top down as shown. Let those 2 folds come open. These are flaps u will use to tuck into pockets (pockets are on opposite side). Make 6.

4
Now u can begin sliding the flaps into pockets. I showed two getting tucked in, it's ur challenge to connect them all. It's really not that hard 😜

Now u can begin sliding the flaps into pockets. I showed two getting tucked in, it's ur challenge to connect them all. It's really not that hard 😜

Supplies

Paper 
keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments