How to Make Jenga Style Blocks for a Wedding

Going to have a piece on each table for guests to sign on, at my friends wedding.

239 Views 6 Likes
How to Make Jenga Style Blocks for a Wedding
13 Steps
Supplies
Embed
1
First I measured how wide 3 pieces side by side were. This will determine the length of my cut

First I measured how wide 3 pieces side by side were. This will determine the length of my cut

2
I clamped a stop block onto the miter saw

I clamped a stop block onto the miter saw

Recommended For You
3
And started cutting all of the boards down to size

And started cutting all of the boards down to size

4
5
I clamped a sander in my vice, upside down and started the long sanding process

I clamped a sander in my vice, upside down and started the long sanding process

6
Please don't mind the mess

Please don't mind the mess

7
I need to clean my garage

I need to clean my garage

8
After all pieces were sanded I used my air compressor to blow them clean

After all pieces were sanded I used my air compressor to blow them clean

9
10
All cleaned up and ready to stamp

All cleaned up and ready to stamp

11
I ended up buying a few sets of letter stamps. I flipped them upside down to make spaces in the names

I ended up buying a few sets of letter stamps. I flipped them upside down to make spaces in the names

12
The two sets on the right were pre made stamps

The two sets on the right were pre made stamps

13
All blocks were stamped on one side and they're ready to go. They were a big hit!

All blocks were stamped on one side and they're ready to go. They were a big hit!

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments