How to Make a Texas Missions Tag With Paper Wings Stamps

by tami sanders * paper crafter

use Texas themed stamps by Paper Wings Productions to make a tag featuring the missions of San Antonio. inks by Clearsnap. tami sanders * paper crafter * www.tamisanders.com

Supplies

  • Paper Wing Productions:San Antonio Missions Stamps
  • Paper Wing Productions: Texas State Stamps
  • Clearsnap: ColorBox Chestnut Roan Chalk Ink
  • Clearsnap: ColorBox Stylus & Tips
  • Clearsnap: ColorBox Color Catcher
  • ColorBox: Spun Sugar Smooch Spritz
  • Prismacolor: Pencils: Sand and Warm Gray
  • Beacon Adhesives: Zip Dry
  • Extra Large Manila Tag
  • Vintage Bead Chain
  • Jute
  • Vintage White String
  • Foam Tape
  • Paper Piercer or Needle
  • Scissors
  • Jewelry Tools
  • Paper Towels
  • Instructions

    Step 1

    San Antonio Missions stamp set by Paper Wings Productions

    Step 2

    place tag in Color Catcher and spritz with Spun Sugar Smooch Spritz

    Step 3

    blot with paper towels to remove and spread excess ink

    Step 4

    stamp Alamo at bottom of tag using Chestnut Roan Chalk Ink

    Step 5

    tear off stamped design at bottom of tag

    Step 6

    stamp "san antonio missions" and "alamo" at side of torn piece of tag using Chestnut Roan Chalk Ink

    Step 7

    ink edges of tag using Chestnut Roan Chalk Ink applied using Stylus & Tip

    Step 8

    cut out pieces and distress edges with Chestnut Roan Chalk Ink

    Step 9

    layout pieces on tag as shown and mark placement with pencil

    Step 10

    stamp missions with names below on tag using Chestnut Roan Chalk Ink

    Step 11

    add color to designs using pencils

    Step 12

    use foam tape to adhere cut pieces to tag

    Step 13

    adhere phrase at top at an angle and alamo at bottom according to marks

    Step 14

    add "alamo" at bottom right of tag

    Step 15

    place bead chain and decide on placement and length

    Step 16

    cut 5 pieces of jute and thread through hole in tag

    Step 17

    use string to tie bead chain to jute

    Step 18

    tie jute, then tie string in a bow, fraying and trimming both as needed

    Step 19

    punch hole at top right of tag to use to attach bead chain

    Step 20

    thread string up to front, tie on chain, then thread to back and knot. make knot large enough so that it will not pull through

    Step 21

    add a dab of glue to secure

    Step 22

    finished tag... please visit Paper Wings Productions to view all their stamp sets... www.paperwingsproductions.com *** visit me - tami sanders * paper crafter at ... www.tamisanders.com