How to Make a Soda Pop Can Tab Bracelet

7.6k Views 765 Likes 1 Comment
How to Make a Soda Pop Can Tab Bracelet
9 Steps
Supplies
Embed
1

Start by cleaning your pop tabs and laying them out in front of you.

2
Cut your pop tabs on the lower heavier portion of the tab right in the middle and lay them out.

Cut your pop tabs on the lower heavier portion of the tab right in the middle and lay them out.

Recommended For You
3
This is how to connect your tabs

This is how to connect your tabs

4
Add 4 tabs per link, making sure to keep them all facing the same way.

Add 4 tabs per link, making sure to keep them all facing the same way.

5
Then begin adding each tab through every other lower tab.

Then begin adding each tab through every other lower tab.

6
Keep going until you have 4 on top and on bottom.

Keep going until you have 4 on top and on bottom.

7
Keep adding 4 tabs per link making sure smooth sides are always facing the same two ways until you reach your length. Then, when bringing the two ends together make sure they are facing opposite ways

Keep adding 4 tabs per link making sure smooth sides are always facing the same two ways until you reach your length. Then, when bringing the two ends together make sure they are facing opposite ways

8
Make sure smooth sides are out and try it on!

Make sure smooth sides are out and try it on!

9
My finished project :)

My finished project :)

keyboard shortcuts:     previous step     next step
Comments
1 COMMENT
View More Comments