How to Make a Soda Can Tab Bracelet

In this guide you are going to learn how to make a soda can tab bracelet.

5.1k Views 453 Likes 1 Comment
How to Make a Soda Can Tab Bracelet
15 Steps
Supplies
Embed
1
Supplies

Supplies

2

You can use any kinds of ribbons as long as the width is small enough to fit through the holes. I used the purple with white sticking.

Recommended For You
3

Next cut the ribbon to 60 inches long. Then at the ends wrap tape around them to make it more easy to weave.

4
Add tap like this to both the ends of the ribbon.

Add tap like this to both the ends of the ribbon.

5
Straighten out the ribbon like so.

Straighten out the ribbon like so.

6
Starting the base

Starting the base

7
Still starting the base.  :)

Still starting the base. :)

8
Now we start weaving. The top string goes in the bottom hole and the bottom string goes in the top hole. Make sure the string goes through both tabs.

Now we start weaving. The top string goes in the bottom hole and the bottom string goes in the top hole. Make sure the string goes through both tabs.

9
Keep doing this until you get the length you like to go around your wrist.

Keep doing this until you get the length you like to go around your wrist.

10
For example...  This is another bracelet but this one is finished with the weaving process.

For example... This is another bracelet but this one is finished with the weaving process.

11
Tying the bracelet off... And... Continues -->

Tying the bracelet off... And... Continues -->

12
Tying off the bracelet.

Tying off the bracelet.

13
Then just tie a knot.

Then just tie a knot.

14
This is what it should look like when you are done.

This is what it should look like when you are done.

15

I hope this guide helped you on how to make a soda can tab bracelet. Enjoy!!!

keyboard shortcuts:     previous step     next step
Comments
1 COMMENT
View More Comments