How to Make a Rubber Band Bow

231 Views 2 Likes
How to Make a Rubber Band Bow
20 Steps
Supplies
Embed
1
Make sure your looms red arrow is pointing away from you.

Make sure your looms red arrow is pointing away from you.

2
Place the bands like this

Place the bands like this

Recommended For You
3
4
5
6
7
8
9
Put a cap band on each of the last two pegs

Put a cap band on each of the last two pegs

10
Start looping.. You're going to take the top band loop it on to its self and the vertical band on itself

Start looping.. You're going to take the top band loop it on to its self and the vertical band on itself

11
Go to the center pin take the top babd and loop it on to itself.

Go to the center pin take the top babd and loop it on to itself.

12
Keep looping

Keep looping

13
Still looping

Still looping

14
It should kinda look a fox

It should kinda look a fox

15
16
"C" clips

"C" clips

17
Get all your band in you clip and close it

Get all your band in you clip and close it

18
Take it off the loom

Take it off the loom

19
Get two other colored rubber babds

Get two other colored rubber babds

20
And wrap them around the middle if the bow and you're done

And wrap them around the middle if the bow and you're done

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments