How to Make a Recycled Soda Can Tab Bracelet

Here is how you make a DIY Beer Tab Bracelet with little materials, easy step by step guide, followed by an awesome and fashionable look that you can wear everyday, specially made by you.

166 Views 11 Likes
How to Make a Recycled Soda Can Tab Bracelet
10 Steps
Supplies
Embed
1
First you want to make sure you have enough Beer Can Tabs, that you'll need in order to make sure that your Bracelet will fit comfortably around your wrist.

First you want to make sure you have enough Beer Can Tabs, that you'll need in order to make sure that your Bracelet will fit comfortably around your wrist.

2
Next you'll need a small handful of jump rings that you'll use to connect your beer tabs.

Next you'll need a small handful of jump rings that you'll use to connect your beer tabs.

Recommended For You
3
You will then pull your Jump Rings apart at an angle. (Do not go straight away from where they connect it will be more difficult)

You will then pull your Jump Rings apart at an angle. (Do not go straight away from where they connect it will be more difficult)

4
If pliers are given they can be also used, but they are not necessary.

If pliers are given they can be also used, but they are not necessary.

5
You will need to place two jump rings on both sides of your tabs as shown in image above.

You will need to place two jump rings on both sides of your tabs as shown in image above.

6
Once you have the Jump rings on both sides and the tabs have already been pinched back closed, you will continue adding rings & tabs until you get the desired length of your bracelet.

Once you have the Jump rings on both sides and the tabs have already been pinched back closed, you will continue adding rings & tabs until you get the desired length of your bracelet.

7
You can choose any color Jump Rings to make your bracelet pop with colors.

You can choose any color Jump Rings to make your bracelet pop with colors.

8
After you have all your Rings & Tabs completely on, you will then add your Lobster Hook onto the end to connect your Bracelet. Keep in mind at the end of your bracelet you will want a ring to do this.

After you have all your Rings & Tabs completely on, you will then add your Lobster Hook onto the end to connect your Bracelet. Keep in mind at the end of your bracelet you will want a ring to do this.

9
This is how your clasped ends will look once your jump ring at end of your bracelet is hooked to your lobster claw and it's all connected.

This is how your clasped ends will look once your jump ring at end of your bracelet is hooked to your lobster claw and it's all connected.

10
How your Bracelet will Look Finished!! GREAT JOB!!

How your Bracelet will Look Finished!! GREAT JOB!!

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments