How to Make a Pea Pod Pendent

With three simple supplies, you can make a cute pendant for someone or yourself.

8.4k Views 634 Likes 1 Comment
How to Make a Pea Pod Pendent
17 Steps
Supplies
Embed
1
Gather your supplies.

Gather your supplies.

2
Put your three beads on your head pin but not all the way to the bottom of the pin. Leave some gap, this is where your 'pod' bottom will be.

Put your three beads on your head pin but not all the way to the bottom of the pin. Leave some gap, this is where your 'pod' bottom will be.

Recommended For You
3
If the holes on your beads are large enough push the wire thru the bottom two beads to hide the end of the wire. *if your beads holes are too small you can just do a few simple tight wraps around it.

If the holes on your beads are large enough push the wire thru the bottom two beads to hide the end of the wire. *if your beads holes are too small you can just do a few simple tight wraps around it.

4
Bend the wire down towards the top of the pod.

Bend the wire down towards the top of the pod.

5
Then wrap the wire around pin once and then bring the wire to the other end cuz the wire will be on the other side of the beads.

Then wrap the wire around pin once and then bring the wire to the other end cuz the wire will be on the other side of the beads.

6
Continue this technique I like to go like 8 to 10 wraps around, it's depends on the size of the beads and how many your using.

Continue this technique I like to go like 8 to 10 wraps around, it's depends on the size of the beads and how many your using.

7
As your going make sure your twists on the head pin are tight together. Makes it look more polished.

As your going make sure your twists on the head pin are tight together. Makes it look more polished.

8
Keep twisting.

Keep twisting.

9
Slowly looking like peas in a pod. The wire stacking on itself makes it look so nice.

Slowly looking like peas in a pod. The wire stacking on itself makes it look so nice.

10
Once your done trim off the spool of wire leaving an half inch tail of wire.

Once your done trim off the spool of wire leaving an half inch tail of wire.

11
Don't forget to slide up the head pin so it's nice on the bottom.

Don't forget to slide up the head pin so it's nice on the bottom.

12
Alright with the little tail I tightly wrapped it around the pin.

Alright with the little tail I tightly wrapped it around the pin.

13
Wrapping it tight makes it look nice.

Wrapping it tight makes it look nice.

14
Ta-Da looks like peas in a pod eh? (Oops that's the Canadian slipping out.)

Ta-Da looks like peas in a pod eh? (Oops that's the Canadian slipping out.)

15
With a round tipped jewelry tool make a loop with  the head pin.

With a round tipped jewelry tool make a loop with the head pin.

16
Super cute and easy to make. It take literally 10 mins to make and everyone loves them.

Super cute and easy to make. It take literally 10 mins to make and everyone loves them.

17
Hope you enjoy.

Hope you enjoy.

keyboard shortcuts:     previous step     next step
Comments
1 COMMENT
View More Comments