How to Make a Log Lamp

How to Make a Log Lamp without screwing through the log!

3.3k Views 353 Likes
How to Make a Log Lamp
11 Steps
Supplies
Embed
1
With a drill for wood drill a hole in the center of the log

With a drill for wood drill a hole in the center of the log

2
Screw threaded tube into the hole

Screw threaded tube into the hole

Recommended For You
3
Vent a bulb and with the glass drill, drill a hole at the edge of the bottom of the bulb. Thread the wire into the hole of the bulb.

Vent a bulb and with the glass drill, drill a hole at the edge of the bottom of the bulb. Thread the wire into the hole of the bulb.

4
5
Screw the fixture to the thread tube to attach it to a log.

Screw the fixture to the thread tube to attach it to a log.

6
Measur with a tape measure the diameter and height of the lampshade

Measur with a tape measure the diameter and height of the lampshade

7
Put the shade on the fabric piece and cut by measurements. Be sure to leave a margin of 3-2 cm. Then spray the shade thin and even layer of spray adhesive.

Put the shade on the fabric piece and cut by measurements. Be sure to leave a margin of 3-2 cm. Then spray the shade thin and even layer of spray adhesive.

8
Paste the fabric on the lampshade. It is important to attach the fabric smoothly to avoid creating bubbles and wrinkles.

Paste the fabric on the lampshade. It is important to attach the fabric smoothly to avoid creating bubbles and wrinkles.

9
Cut the remaining fabric with scissors.

Cut the remaining fabric with scissors.

10
Attach a Jute rope  to the edge of the lampshade with hot glue or fabric adhesive

Attach a Jute rope to the edge of the lampshade with hot glue or fabric adhesive

11
Put the shade on the fixture and screw into shot.

Put the shade on the fixture and screw into shot.

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments