How to Make a Duct Tape Rose

732 Views 65 Likes
How to Make a Duct Tape Rose
12 Steps
Supplies
Embed
1
Step 1: Cut off the bendy end of the straw.

Step 1: Cut off the bendy end of the straw.

2
Step 2: Roll out some duct tape and place the straw on the sticky side.

Step 2: Roll out some duct tape and place the straw on the sticky side.

Recommended For You
3
Step 3: Cut the tape at the end of the straw.

Step 3: Cut the tape at the end of the straw.

4
Step 4:  Roll the straw up in the tape tightly. Make sure there are no bumps in it.

Step 4: Roll the straw up in the tape tightly. Make sure there are no bumps in it.

5
Step 5: measure out some more duct tape. Each piece has to be 2inches each, and cut them.

Step 5: measure out some more duct tape. Each piece has to be 2inches each, and cut them.

6
Step 6: Fold one corner over so that is makes half a triangle, sticky side touching sticky side.

Step 6: Fold one corner over so that is makes half a triangle, sticky side touching sticky side.

7
Step 7: Fold the other end just like the first, leaving some of the sticky side at the bottom.

Step 7: Fold the other end just like the first, leaving some of the sticky side at the bottom.

8
Step 8: Roll that piece up tightly.

Step 8: Roll that piece up tightly.

9
Step 9: Place that piece into one end of the straw.

Step 9: Place that piece into one end of the straw.

10
Step 10: Repeat steps 6-7 and wrap the petals around the start.

Step 10: Repeat steps 6-7 and wrap the petals around the start.

11
Step 11: Make it as big as you want.

Step 11: Make it as big as you want.

12
Step 12: to make the leaves, do the same steps as you did for the petals and place them at the bottom.

Step 12: to make the leaves, do the same steps as you did for the petals and place them at the bottom.

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments