How to Make a Candleholder

How to make big a metal candle holder.

2k Views 28 Likes 1 Comment
How to Make a Candleholder
24 Steps
Supplies
Embed
1
This is a guide on how to make a metal candleholder

This is a guide on how to make a metal candleholder

2

This is a guide on how to make a big metal candleholder.

Recommended For You
3
I'm starting with my flatbar first. Use a metal ruler and a scribe and mark out however much flatbar you need.

I'm starting with my flatbar first. Use a metal ruler and a scribe and mark out however much flatbar you need.

4
Use the hacksaw to saw off the flatbar. Repeat however many times you need.

Use the hacksaw to saw off the flatbar. Repeat however many times you need.

5
Once you've finished, use the file and file the edges until smooth.

Once you've finished, use the file and file the edges until smooth.

6
Scroll the flatbar around the mould to the shape you want.

Scroll the flatbar around the mould to the shape you want.

7
Use the scribe and mark 2cm from the end of the flatbar.

Use the scribe and mark 2cm from the end of the flatbar.

8
Use the ball pein hammer and centre punch to make a little hole to make it easier to drill.

Use the ball pein hammer and centre punch to make a little hole to make it easier to drill.

9
Use the centre punch and ball pein hammer again to punch a hole in the middle of the flatbar.

Use the centre punch and ball pein hammer again to punch a hole in the middle of the flatbar.

10
To make legs, use the ball pein hammer to hammer the shape of the legs.

To make legs, use the ball pein hammer to hammer the shape of the legs.

11
Drill a hole where you marked using the drill press, don't forget to wear safety glasses

Drill a hole where you marked using the drill press, don't forget to wear safety glasses

12

You are now finished the flat bar, now onto the wax catcher.

13
Measure out a piece of sheet metal 7x7 using the metal ruler and scribe

Measure out a piece of sheet metal 7x7 using the metal ruler and scribe

14
Cut the sheet metal using the guillotine

Cut the sheet metal using the guillotine

15
Mark a cross into the metal so you can find the centre

Mark a cross into the metal so you can find the centre

16
Using the divider, mark a circle into the metal

Using the divider, mark a circle into the metal

17
Using the centre punch and ball pein hammer, punch a hole where the middle of the cross is

Using the centre punch and ball pein hammer, punch a hole where the middle of the cross is

18
Use the tin snips and cut out the circle as well as you can

Use the tin snips and cut out the circle as well as you can

19
Secure the metal into the vice and file the metal so it has no sharp edges

Secure the metal into the vice and file the metal so it has no sharp edges

20
Then, using a ball pein hammer and mould, hammer from the outside to the inside to make a curved shape

Then, using a ball pein hammer and mould, hammer from the outside to the inside to make a curved shape

21

Then drill a hole in the centre of your dish

22
You then pop rivet your dishes onto your pieces and weld if needed

You then pop rivet your dishes onto your pieces and weld if needed

23
Then use sandpaper and sand your candleholder until it's smooth

Then use sandpaper and sand your candleholder until it's smooth

24
You can then paint it or just leave it as is and use it whenever you want!

You can then paint it or just leave it as is and use it whenever you want!

keyboard shortcuts:     previous step     next step
Comments
1 COMMENT
View More Comments