How to Make a Bracelet

Easy to make and so cute!

642 Views 75 Likes
How to Make a Bracelet
18 Steps
Supplies
Embed
1

Measure and cut 4 lengths of beading cord. 24 inches each for a bracelet, 30 inches each for an anklet, and 45 inches each for a necklace.

2
Cord is cut! I'll be making a bracelet in this guide, so I cut 24 inch lengths of cord.

Cord is cut! I'll be making a bracelet in this guide, so I cut 24 inch lengths of cord.

Recommended For You
3
Grab all 4 of the cords and make a huge knot about a half inch from one end.

Grab all 4 of the cords and make a huge knot about a half inch from one end.

4
Tape the knotted end of the cords to your work surface.

Tape the knotted end of the cords to your work surface.

5
Pull the middle 2 cords straight and tape them down too. These will be your base cords.

Pull the middle 2 cords straight and tape them down too. These will be your base cords.

6
Fold the right-most cord over the base stands and under the left-most strand.

Fold the right-most cord over the base stands and under the left-most strand.

7
Now fold the left-most cord under the base cords and over the right-most cord.

Now fold the left-most cord under the base cords and over the right-most cord.

8
Pull tightly on both cords to make a knot.

Pull tightly on both cords to make a knot.

9
If you don't want to add beads, continue making knots like this until you get the desired length.

If you don't want to add beads, continue making knots like this until you get the desired length.

10

If you mess up, just un-knot the last knot and start over!

11

If you don't want to add beads to your band, skip ahead to Step 15. These next steps are for if you do want to add beads to your band.

12
Remove the tape from the base cords only, and slid a bead onto them.

Remove the tape from the base cords only, and slid a bead onto them.

13
Re-tape the base cords and continue knotting like before.

Re-tape the base cords and continue knotting like before.

14

Add as many beads as you like!

15
When you have reached your desired length (yes, the base cords will be longer than the band), remove all tape and knot both ends of the band together. Cut off any excess thread.

When you have reached your desired length (yes, the base cords will be longer than the band), remove all tape and knot both ends of the band together. Cut off any excess thread.

16
Finished product!

Finished product!

17
Another version, I made an anklet.

Another version, I made an anklet.

18

If you have any questions, leave me a comment and I'll try to answer them!

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments