How to Make a Beaded Bracelet

by alyssa 💕

By Alyssa Mead

Supplies

  • Clear stretchy string
  • Yarn
  • Small round beads
  • Scissors
  • Tape
  • Clip board
  • Instructions

    Step 1

    These are all of the supplies that you will need.

    Step 2

    Now cut a piece of yarn about 24 in. Long

    Step 3

    Then cut a piece of your clear string the same size as your yarn.

    Step 4

    Fold both the clear string and yarn in half then tie a knot where the loops are.

    Step 5

    Now put the strings in the clipboard and line the strings up so that the clear ones are on the outside and the yarn is on the inside.

    Step 6

    Now tape the yarn a finger space away at the bottom of the strands like in the photo.

    Step 7

    Now take the clear string on your left side and thread it through the left side of the bead and do the same to the right strand but stick it though the right side of the bead. Now pull tight.

    Step 8

    Take the clear string in the right side and stick it under the yarn strand on the right then pull though. Do the same on the left side.

    Step 9

    Now add the bead. To add the bead slip one end of the clear string through the bead hole closest to it. Do the same with the other string

    Step 10

    Keep repeating steps 8 & 9 until the end of your bracelet.

    Step 11

    When you are done, tie many knots with the strings like I did. Then take it off the clip board.

    Step 12

    Take half of the strings and put them though the loop then tie 3 knots.

    Step 13

    Now you have your finished bracelet (or ring) using this beaded pattern!!