How to Make a Beaded Bracelet

By Alyssa Mead

591 Views 27 Likes
How to Make a Beaded Bracelet
13 Steps
Supplies
Embed
1
These are all of the supplies that you will need.

These are all of the supplies that you will need.

2
Now cut a piece of yarn about 24  in. Long

Now cut a piece of yarn about 24 in. Long

Recommended For You
3
Then cut a piece of your clear string the same size as your yarn.

Then cut a piece of your clear string the same size as your yarn.

4
Fold both the clear string and yarn in half then tie a knot where the loops are.

Fold both the clear string and yarn in half then tie a knot where the loops are.

5
Now put the strings in the clipboard and line the strings up so that the clear ones are on the outside and the yarn is on the inside.

Now put the strings in the clipboard and line the strings up so that the clear ones are on the outside and the yarn is on the inside.

6
Now tape the yarn a finger space away at the bottom of the strands like in the photo.

Now tape the yarn a finger space away at the bottom of the strands like in the photo.

7
Now take the clear string on your left side and thread it through the left  side of the bead and do the same to the right strand but stick it though the right side of the bead. Now pull tight.

Now take the clear string on your left side and thread it through the left side of the bead and do the same to the right strand but stick it though the right side of the bead. Now pull tight.

8
Take the clear string in the right side and stick it under the yarn strand on the right then pull though. Do the same on the left side.

Take the clear string in the right side and stick it under the yarn strand on the right then pull though. Do the same on the left side.

9
Now add the bead. To add the bead slip one end of the clear string through  the bead hole closest to it. Do the same with the other string

Now add the bead. To add the bead slip one end of the clear string through the bead hole closest to it. Do the same with the other string

10

Keep repeating steps 8 & 9 until the end of your bracelet.

11
When you are done, tie many knots with the strings like I did. Then take it off the clip board.

When you are done, tie many knots with the strings like I did. Then take it off the clip board.

12
Take half of the strings and put them though the loop then tie 3 knots.

Take half of the strings and put them though the loop then tie 3 knots.

13
Now you have your finished bracelet (or ring) using this beaded pattern!!

Now you have your finished bracelet (or ring) using this beaded pattern!!

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments