How to Create a Layered Flower Hair Bow

Now make this fun layered flower bow!

742 Views 73 Likes
How to Create a Layered Flower Hair Bow
18 Steps
Supplies
Embed
1
Supplies

Supplies

2
Cut 4, 9 1/4 in inches of ribbon, heat seal

Cut 4, 9 1/4 in inches of ribbon, heat seal

Recommended For You
3
Put a little bit of glue on the end

Put a little bit of glue on the end

4
Take the other end and put it over the glue

Take the other end and put it over the glue

5
Put a little bit of glue on the inside

Put a little bit of glue on the inside

6
And the find the center and push down, do it to the other pieces of ribbon

And the find the center and push down, do it to the other pieces of ribbon

7
Put it down and put glue in the middle

Put it down and put glue in the middle

8
Lay another piece if ribbon on top

Lay another piece if ribbon on top

9
And repeat 7 and 8 over again until you use up all of the ribbon

And repeat 7 and 8 over again until you use up all of the ribbon

10
Cut 4, 6 1/2 inches of a different ribbon and heat seal

Cut 4, 6 1/2 inches of a different ribbon and heat seal

11
Repeat step 3 to 8 over again to make the other flower

Repeat step 3 to 8 over again to make the other flower

12
Put the two bows together with glue

Put the two bows together with glue

13
Add a jewel with glue

Add a jewel with glue

14
Cut a 3/8 inch piece of ribbon and heat seal. Then put some glue on the end and slip it on the alligator clip

Cut a 3/8 inch piece of ribbon and heat seal. Then put some glue on the end and slip it on the alligator clip

15
Add glue on the top and pull the ribbon over

Add glue on the top and pull the ribbon over

16
Then put some glue on the back and put the ribbon over it

Then put some glue on the back and put the ribbon over it

17
Glue it on the back, ribbon side

Glue it on the back, ribbon side

18
Now you're done!

Now you're done!

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments