How to Create a Fall Wreath Plaque

by Prima Marketing

Create a gorgeous fall wreath plaque in just a few steps and with just a handful of Prima products! Created by Sharon Laakkonen

Supplies

  • 583057 Carte Blanche Plaque
  • 553630 Vermont Leaves - Brown
  • 553647 Vermont Leaves - Ochre
  • 577087 Weave Trim - Camel
  • 583545 Metals for Wood Plaque
  • 921293 Elle Flowers - Gold/Orange
  • Fabri-Tac Adhesive
  • Pencil
  • Scissors
  • Thin Paint Brush
  • Instructions

    Step 1

    Trace a 4 inch circle on the wood blank as a reference for creating your wreath.

    Step 2

    Add three orange flowers as shown.

    Step 3

    Cut wire stems off of leaves as shown. Save wires for later.

    Step 4

    Set leaves on circle to create a wreath, overlapping them. Save one for later. Do not glue leaves down until you are happy with the arrangement.

    Step 5

    Tip: only add glue to center of flower and leaf backs so you can overlap them for a natural look.

    Step 6

    Cut a leaf in half.

    Step 7

    Tuck leaf halves in to "bald" areas as shown. Adhere.

    Step 8

    Curl wire stems onto a thin paintbrush. Pull off, then bend each curled piece in half.

    Step 9

    Add glue to bent section of curled wires and tuck in around flowers as shown.

    Step 10

    Tie a bow out of trim and tuck slightly under wreath, adhering with fabric glue. Your fall wreath plaque is now ready to hang up in your home!