How to Create a Fall Wreath Plaque

Create a gorgeous fall wreath plaque in just a few steps and with just a handful of Prima products! Created by Sharon Laakkonen

320 Views 24 Likes
How to Create a Fall Wreath Plaque
10 Steps
Supplies
Embed
1
Trace a 4 inch circle on the wood blank as a reference for creating your wreath.

Trace a 4 inch circle on the wood blank as a reference for creating your wreath.

2
Add three orange flowers as shown.

Add three orange flowers as shown.

Recommended For You
3
Cut wire stems off of leaves as shown. Save wires for later.

Cut wire stems off of leaves as shown. Save wires for later.

4
Set leaves on circle to create a wreath, overlapping them. Save one for later. Do not glue leaves down until you are happy with the arrangement.

Set leaves on circle to create a wreath, overlapping them. Save one for later. Do not glue leaves down until you are happy with the arrangement.

5
Tip: only add glue to center of flower and leaf backs so you can overlap them for a natural look.

Tip: only add glue to center of flower and leaf backs so you can overlap them for a natural look.

6
Cut a leaf in half.

Cut a leaf in half.

7
Tuck leaf halves in to "bald" areas as shown. Adhere.

Tuck leaf halves in to "bald" areas as shown. Adhere.

8
Curl wire stems onto a thin paintbrush. Pull off, then bend each curled piece in half.

Curl wire stems onto a thin paintbrush. Pull off, then bend each curled piece in half.

9
Add glue to bent section of curled wires and tuck in around flowers as shown.

Add glue to bent section of curled wires and tuck in around flowers as shown.

10
Tie a bow out of trim and tuck slightly under wreath, adhering with fabric glue.  Your fall wreath plaque is now ready to hang up in your home!

Tie a bow out of trim and tuck slightly under wreath, adhering with fabric glue. Your fall wreath plaque is now ready to hang up in your home!

keyboard shortcuts:     previous step     next step
Comments
0 COMMENTS
View More Comments