- 1
-
Open side cover and front cover incl. control box
- 2
-
Just take top of the machine a control box, the cable enough long.
- 3
-
Take out the side panel screw, and take out a side panel.
- 4
-
This is the left hand side of the machine with the belt.
- 5
-
Right hand side of the machine, pump house, top of the picture the pump. Necessary to take out.
- 6
-
Motor and a belt adjustment spring. Take out, and then loose hold of the belt.
- 7
-
Take out drum, this special bearing hold the drum the back side. Front there are 2 rubber wheal support the drum. ( very clever idea.)
- 8
-
After we are take out the drum. There was a two rubber supporter wheals.
- 9
-
Now take out the pump.
- 10
-
This is the condensation house and a black pipe goes to pumps to top reserve tank.
- 11
-
This is a problem !
- 12
-
This is the pump
- 13
-
The condensation tank bottom is full of tow. It is possible one year working process, the tow go through filter, and mixing the weather and stopped pump.
- 14
-
Take out the drum supporter wheal
- 15
-
Take out a condensation. Carefully wiring!
- 16
-
Now take out whole condensation system, radiator and motor as well.
- 17
-
This is the front condensation, radiator.
- 18
-
This is the place of the condensation motor.
- 19
-
Condensation house full of the tow.
- 20
-
Look at this tow
- 21
-
Amassing tow. This is stopped the pump.
- 22
-
Necessarily to clean 100%.
- 23
-
I surprised how much tow in it.
- 24
-
Cleaning...
- 25
-
This is a condensation and a motor.
- 26
-
Drum, and parts.
- 27
-
Now cleaned all, I used anti static rag, and a normal rag with soap. I cleaned whole base house until like a new!
- 28
-
Take apart a pump. Clean and take back again.
- 29
-
Back condensation and a motor.
- 30
-
Take back a top of the condensation house. Carful every screw position and tight. We don't wand a leaking system.
- 31
-
Take back a pump, and cables.
- 32
-
Clean every part of the machine, same as a factory shape. Take back a weather reserver tank.
- 33
-
Take back a front panel and a vertical weather pipe ( white one).
- 34
-
Take to back the black pipes & right side top side supported steel.
- 35
-
Now it is possible take back a drum and after a back panel. Be careful screw some drift are metal, some spiral are plastic one.
- 36
-
Checked every detail.
- 37
-
back motor spring and testing machine. It is start testing right side panel is off. Start a test program. WERY CAREFULLY. Moving belt,motor 220 V. If you are not a electrical expert do not do that.