Find a cable drum with the desired height an width. I wanted min low and wide
Place the wheels
Make sure the wheels don't stick out, or it will annoy you later on...
Drill a hole before screwing the screws in. This will prevent the wood from splitting
2 screws for each wheel should do. If - like in my case - the screws are to small, add a washer
Remove small nails and stuff
Be patient, there might be a lot...
Don't remove the large nails, they hold the drum together. If they stick out, use a hammer and a piece of metal to lower them
Sand it down, not to much or it will ruin the rustic look. Optional: oil
And you're done 🐒