Hello, peeps. I'm going to show you how to make this...
Little Lego speeder.
First, you are going to take two 1x6 curved pieces and put a rounded piece on bottom.
Next, take a 2x6 and put a flat 1x2 two spaces from one of the ends.
And put those pieces together.
Next, you are going to take a 3 stud corner piece, put a claw on the left side with the point facing out, and put a pole piece in the claw.
And connect that with the body part.
Now, take a 1x1 brick with hole in it, take a claw piece and the other pole part, and connect them like this.
Connect to the body.
Now, take a 1x2 with holes in the side and put these pieces in it.
Take a lever piece and a flat 1x2 and add them to the 1x2.
Add that to the side of the body.
Take a 1x2 and add that to the side of the front.
Now, take one of these and put it on the side of the front. You can put whatever you want on this part.
Take one of these pieces, (I honestly don't know the names of all these Legos. Sorry), and put it on the front.
Customize how you want.
Connect a 3 stud L piece, a 1x1 piece, and binoculars on the piece to secure the connection you just made.
Ok, so put the body to the side. Grab two 1x2 flat pieces, two hinge pieces, some on those round triangle pieces and this.
Connect them like this.
Take a hinge piece, a vented cheese slope, and a normal cheese slope and connect them like this.
Put that on the left side of the back.
Make a similar piece, but instead of the vented cheese slope, take a normal 1x2 flat piece.
Connect it in the same way as the other one.
For this last part, you can put whatever you want on the back of this. I chose to put a torch on it and a pistol holder.
And finally, connect that to the back of the body.
Note: you do not need to use the same color pieces for this tutorial.
That's it, guys. Thanks for following this guide and I hope you enjoy your new Lego speeder.