How to Attach a Small Torch (Flashlight) to Your Belt

1.4k Views 17 Likes 1 Comment
How to Attach a Small Torch (Flashlight) to Your Belt
7 Steps
Supplies
Embed
1
Cut a length of approximately 15cm of webbing strap. Heat seal the ends using a lighter or match to stop it fraying.

Cut a length of approximately 15cm of webbing strap. Heat seal the ends using a lighter or match to stop it fraying.

2
Obtain a small torch, LED type is best. It's better to use one that has a narrower middle with wider ends, this will prevent it from sliding out.

Obtain a small torch, LED type is best. It's better to use one that has a narrower middle with wider ends, this will prevent it from sliding out.

Recommended For You
3
Attach a male press stud close to one end.

Attach a male press stud close to one end.

4
Place the strap around your belt and torch to find the right position for the female press stud. This should be attached on the opposite side of the strap.

Place the strap around your belt and torch to find the right position for the female press stud. This should be attached on the opposite side of the strap.

5
Strap shown with both press studs attached.

Strap shown with both press studs attached.

6
The press studs should connect the strap together in a loop.

The press studs should connect the strap together in a loop.

7
Fit the completed strap around your belt and torch. Now you'll always have a torch available when you need one.

Fit the completed strap around your belt and torch. Now you'll always have a torch available when you need one.

keyboard shortcuts:     previous step     next step
Comments
1 COMMENT
View More Comments