How to Make a Triple Single Rubber Band Bracelet

4k Views 86 Likes 15 Comments
1
Get your colors ready that you are going to use. My loom is 13x3, so I get 13 sets of colors and 3 of each. Start with the arrow pointing AWAY from you.

Get your colors ready that you are going to use. My loom is 13x3, so I get 13 sets of colors and 3 of each. Start with the arrow pointing AWAY from you.

2
As you can see, you get each color and place the bands on the pins. Continue that until you make it to the top.

As you can see, you get each color and place the bands on the pins. Continue that until you make it to the top.

Recommended For You
3
Your loom should look like this :D

Your loom should look like this :D

4
Now make upside down triangle all the way up the loom. DONT make one on the first one. As you can see.

Now make upside down triangle all the way up the loom. DONT make one on the first one. As you can see.

5
It should look like this.

It should look like this.

6
Now turn your loom around so the triangles are pointing up as shown.

Now turn your loom around so the triangles are pointing up as shown.

7
Now get you pick and pull it up to the next pin. Until you make it to the top.

Now get you pick and pull it up to the next pin. Until you make it to the top.

8
It should look like that.

It should look like that.

9
At the top, you take the loops on the left and the right and bring them to the middle like shown.

At the top, you take the loops on the left and the right and bring them to the middle like shown.

10
Pass through all the loops on the center pin and pull a new band through halfway as shown. Slide the pick tool through the opposite end of the new band so it stays there as shown.

Pass through all the loops on the center pin and pull a new band through halfway as shown. Slide the pick tool through the opposite end of the new band so it stays there as shown.

11

Carefully remove the bracelet from the loom, NOT removing the pick from the end.

12
Beautiful! Now set that aside.

Beautiful! Now set that aside.

13
Make sure the arrow is pointing away from you, starting at the bottom place the bands on the loom. The more bands the bigger the bracelet.

Make sure the arrow is pointing away from you, starting at the bottom place the bands on the loom. The more bands the bigger the bracelet.

14
Transfer the bands on the pick tool to the last pin that you have put your extension on. Loop the bands straight up until the top.

Transfer the bands on the pick tool to the last pin that you have put your extension on. Loop the bands straight up until the top.

15
It should look like this.

It should look like this.

16
Clip both ends together

Clip both ends together

17
ENJOY!

ENJOY!

keyboard shortcuts:     previous step     next step
Comments
15 COMMENTS
View More Comments