Take your lanyard lace and measure 36 inches, cut with scissors. You will need 22 to 28 soda tabs depending on your wrist size.

Fold your lace in half and stick both ends through the soda tab. Face your soda tab rough side up.

Pull the lace ends all the way through the soda tab.

Put a soda tab (smooth side up) on top of the other soda tab.

Take the bottom lace and cross over to the top hole and put it through. Do the same thing to the top lace but to the bottom hole. This will make an X with the lace.

Place your next soda tab(rough side up) and put it under the last soda tab.

Take the top lace and put it through the top hole. Take the bottom lace and put it through the bottom hole.

Take another soda tab ( smooth side up) and put it on top of the last soda tab. Repeat step 5 and make another X with the lace.

Continue steps 4-8 until you have your desired length. 22 (for children) and 26-28 (for adults).

Once you have the length that you want. Take the beginning of your bracelet and put it under your last soda tab. Repeat step 7 and 8. Once your lace Osborn the inside of the bracelet make to knots.

Put a little crazy glue on the knot and let it sit for 5 mins so the knot doesn't come undone and so you don't have to re-lace your entire bracelet again, after cutting the excess lace.

And your bracelet is done :). I like using the lanyard lace because it makes the bracelet a little stretchy so it is easy to take on and off without tying. I hope you enjoy how I make my ST bracelet.