How to Make a Paracord Bracelet and Dog Collar

19.5k Views 1449 Likes 36 Comments
1
Image for Step 1

Materials Needed: 550 Paracord (order online or found in local Army Navy Stores), Measuring tape, Lighter, Scissors.

2
Image for Step 2

Measure off about 22 inches for the bracelet core. Fold and form a loop as shown. Then tie an overhand knot where the two ends meet.

Recommended For You
3
Image for Step 3

Cut off a 4 ft section of each color paracord. Use a lighter to heat both ends. Push both ends together and allow them to fuse together. Be careful not to burn yourself.

4
Image for Step 4

Both cords have fused and cooled. Again--be careful! Melted paracord will BURN you! (Note: as an option you could stick with one cord color and avoid this step)

5
Image for Step 5

Bring the red/black fused cord behind the white loop.

6
Image for Step 6

Bring one cord (red side) around to the front of the white cord and form an S shape loop. This begins the Cobra Weave.

7
Image for Step 7

Bring black cord around and enter the red loop (left side), go around back of the white cord and then exit the red loop (right side)

8
Image for Step 8

Cinch the knot formed from the previous step. It should look similar to the image shown. Leave out 1 inch of white cord loop as pictured. The white loop will clasp the finished bracelet together.

9
Image for Step 9

Repeat the same operation as before, but this time create the S loop from the opposite side. Pull the black cord through and cinch up the knot.

10
Image for Step 10

Continue repeating the Cobra Weave, and you will see a pattern emerge.

11
Image for Step 11

Continue the Cobra Weave and stop when you are about 1/2 inch from the overhand knot.

12
Image for Step 12

Once you have tested the bracelet for fit and made adjustments, cut the excess cord with scissors and singe the cut ends with the lighter. Be careful! Don't allow melted cord to touch your skin.

13
Image for Step 13

Finished bracelet - enjoy! Now onto the dog collar.

14
Image for Step 14

Please make me a new dog collar. Please, please, pretty please!

15
Image for Step 15

I use a cheap $5 collar from a regular department store. Get one that fits your dog perfectly. I will use the Cobra Weave from previous steps, but this time I'll weave around the collar.

16
Image for Step 16

Fuse cords together with lighter, and tie the starting knot as shown in the previous steps for the bracelet. Note how I've used duct tape to hold the collar down while I weave.

17
Image for Step 17

Continue weaving down the length of the collar.

18
Image for Step 18

Weave around the adjustment slide. Make sure collar fits your pet properly because you may not be able to adjust the slide with the paracord weaved around the collar.

19
Image for Step 19

Once you have arrived at the other buckle, cut excess cord with scissors and singe ends. The finished product is shown above.

20
Image for Step 20

One happy doggy!

keyboard shortcuts:     previous step     next step
Comments
36 COMMENTS
View More Comments