Sign In with Facebook or Twitter
Or use your email address
How to Make a Duct Tape Bead Bracelet
Supplies
First let's make the beads.
Cut duct tape at 8 inches long
Use a ruler and cut the duct tape in half
Put a mark in the middle of the one end
Use a ruler and cut from the mark to the outside tip on both sides
There it is cut. I'm using the one in the middle but keep the others you can use those too.
Wet the tip above my finger
Keep doing this until it looks like ------->
------> this. Ta da, a bead
This is what the side pieces (the small left overs) look like
Now you can thread them into a necklace or a bracelet or do what ever you can think of is cute with them.
Thread your needle and thread.
The beads threaded.
Tie a knot and you are done. Enjoy and be creative!! XD
Check out other guides by this author!
Keep Exploring
Start Over
Different kinds of duct tape
Ruler
Cutting board
Exacto Knife
Wire
Thread
Needle
Skylar Reed 2 months ago
Valerie Ventura 11 months ago
Be first to comment on Step 1.
Be first to comment on Step 2.
Be first to comment on Step 3.
Be first to comment on Step 4.
Be first to comment on Step 5.
Be first to comment on Step 6.
Be first to comment on Step 7.
Be first to comment on Step 8.
Be first to comment on Step 9.
Be first to comment on Step 10.
Be first to comment on Step 11.
Be first to comment on Step 12.
Be first to comment on Step 13.
Be first to comment on Step 14.
Be first to comment on Step 15.